In Creo 3.0 parametric student edition, can I merge an assembly file called bearing.asm to a part file without causing the already finished final assembly to fail regeneration? Essentially, my issue is with parts that make up the bearing assembly (which was downloaded from McMaster) showing up on the auto fill Bill of Materials in the final assembly which then causes them to be part of the balloons as well. Basically I just want the BOM to have one entry for the hole bearing. Thanks.
P.S. I realize that this was caused by my own mistake when bringing the parts into Creo as assemblies instead of parts. I did not realize my mistake until now, and reassembling the final project will take too much time since I have to submit by midnight tonight.